PDA

View Full Version : Hanger setup



ItsElectric
09-19-03, 10:09 AM
I probably shoulda posted this in the Hanger's forum, but I'm not sure how many of you go there, so I'll just post here (move if you want :)). I plan on going out sometime and buying this setup (the chair and the stool) after I find them somewhere.

The reason I need this is because my current chair's seat is too wide to get a good angle, and it's too low to the ground. When I move up past 10lbs I'll have to sit on my desk and put my feet in my chair, until I get this:

http://jamie.ee99ee.com/hanger.gif

Any suggestions or comments would be appreciated.

-ItsElectric

stillwantmore
09-19-03, 12:00 PM
Havent you seen my thread on what I was using?

http://www.mattersofsize.com/forum/showthread.php?s=&threadid=687

As long as you have a similar set up...you have enough ground clearance for the weights and a place to prop your feet that causes your hips to tilt up toward you, you'll be fine.

ItsElectric
09-19-03, 01:00 PM
Yeah I saw your setup, but I wasn't sure if you leaned back while doing it. I guess that's what you mean by tilting your hips toward you.

-ItsElectric

stillwantmore
09-19-03, 03:31 PM
Naw man, with that set up, my feet were up just enough where if I scooted my ass a little more toward the edge of the chair...BTC was 100% there.