Hello Brotherhood,
This is my first post in this community, and I came here to share with you a tutorial on the use of VLC while you sleep!
I saw many brothers complaining that the device would come off, so I came up with a fix.
Materials:
-VLC Tugger
-VLC Strap
-Micropore tape
-Small plastic bag/sock (I used the plastic bag that came wrapping my andro extender parts, so a thick plastic is recommended)
-PVC pipe (the pipe width should be wider than your VLC cone and your erect width; cut it about 10inch/25cm long and smooth out the edges; and of course, clean it!)
Assembly
e.jpg
1. Put the VLC tugger device.
2.jpg
2. Apply the micropore tape over the prepuce.
I recommend you to not roll too much skin, if not, you will gain more skin.
One wrap is enough.
After you do that, pull the device to check if the tugger comes off. If it does, wrap again.
3.jpg
3. Put the VLC skin cone.
4. Put your penis in the plastic bag.
The top of the bag should be in contact with the tugger ring.
4.jpg
5. Apply the strap on the bag and the tugger ring at the same time.
Make sure that the bottom of the bag covers the entire VLC cone.
5.jpg
6. Pass the wrap through the pipe and pull your penis inside of it.
Pull and release the strap to check if the plastic bag is sliding inside the pipe.
Tug the strap over your shoulder.
6.jpg
*Attention, I advise to you to use a small tension because this aparatus might increase the size of your skin.
I know this whole apparatus is kind of big, but it should not bother you if you sleep sideways or on your back.
If you find this tutorial helpful, please stick it.
Feedback is greatly appreciated.
Bookmarks