User Tag List

Likes Likes:  0
Thanks Thanks:  0
Results 1 to 9 of 9
  1. #1
    Join Date
    Dec 2003
    Posts
    8,655
    Post Thanks / Like
    Blog Entries
    2
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Rep Power
    24

    Advanced Pumping Techniques: Effective Time

    TIME AND THE PUMPING PROCESS
    Many pumpers feel that they grow fast in the early part of a pump session, then seem to "Plateau" or reach a point where enlargement either stops or greatly slows down. It would seem logical to say that the longer you pump, the larger you would get. Not necessarily true!

    The question is one of effective time. "Effective" means any time when the flow and gain of fluids that cause enlargement is taking place at the desired rate, and that is not something that occurs continually. Effective time also varies in the level of efficiency- as the flow reduces, the level drops. Pumping up faster or larger is a factor of effective time only. Time spent in the pump that's not effective is totally wasted.

    This fluid flow and gain process that creates enlargement is restricted by the pumping operation itself, in these three ways:


    As swelling takes place, tissues are engorged- including those of the passageways bringing fluid in, actually reducing the diameters of those passageways.

    There is a pinching pressure attempting to close these passageways right at the point where the cylinder entry meets your body. The passageways are part of the tissue being compressed by the sealing surface of the tube.

    It is further complicated by another easily demonstrated process, that of "vacuum collapse". Take a soft tube, and connect it to your vac pump. With an open end, it will suck indefinitely. Now squeeze the tube down in the middle. As the opening gets narrower, two things happen. One, the flow through the restriction reduces- and two, the vac level on the restricted portion increases. There comes a point where the internal vacuum itself pulls the tube closed- and all flow stops.
    All of these conditions combine to either restrict or stop the process of enlargement. The longer the condition lasts, the tighter the restriction can get- and thereby further reducing the level of effectiveness, ultimately ending effective time altogether. The issue is one of making all the time in the pump effective time, and maximizing the level of that effectiveness.

    HOW DO YOU FIND OUT WHAT WORKS?
    We did an experiment to try and measure the extent of this. To determine exactly what gain was occuring, we went to Displacement Pumping. (Explained in another Advanced Pumping Article) Two pumpers who run close to the same in size and usual enlargement rate provided the comparisons. We selected the one that usually pumped up faster as the control subject; and the slower one as the test subject. Both used STJ's as cylinders, and both pumped wet with precisely the same level of water in the jar. Both jars were marked for measurement by adding water that had been precisely measured and creating a CC (Cubic Centimeter) scale on the side The scale started with the zero set at the water mark with the jar vertical and inverted, with enough water to cover the pumper. As the enlargement develops, it displaces water and raises the level on the scale- precisely measuring the volume of change. We did this experiement on four occasions using different schedules each time, with substantially different results.

    The control subject would pump at a vac level of 5", and hold it for 60 minutes.

    The test subject would pump at the same vac level, but would interrupt the session with an alternate state as called for by the experiment schedule.

    The result is measured in relative terms:
    The change in volume (actual gain) of the test subject, as compared to the control subject expressed as a plus or minus percentage. The volume of the control subject's gain over the zero mark would always be 100. If the test subject developed 10% less gain, the test score would be 90%. If the gain was identical, the score would be 100%; if the gain was 10% more, the score would be 110%. The "Relative effectiveness" is the score points gained per minute; obtained by dividing the score by the time at level.

    Four test schedules were tried, as follows:


    Break at 15 minute intervals, exit and massage 2 minutes, return to vac level. (3 breaks)

    Reduce vac level to zero once every 15 minutes, hold zero for 1 minute, return to level.

    Reduce vac to zero every once every 10 minutes, hold zero for 1 minute, return to level.

    Reduce vac to 1" every 5 minutes, hold for 30 seconds, return to level.
    Here's the scorecard of the test subject for these tests:

    SCHEDULE SCORE TIME @ LEVEL RELATIVE EFFECTIVENESS
    CONTROL 100 60 MINUTES 1.66
    #1 108 54 MINUTES 2.00
    # 2 111 57 MINUTES 194
    # 3 121 54 MINUTES 2.24
    # 4 133 54 MINUTES 2.46


    SO-WHAT DOES IT MEAN?
    In every schedule, taking breaks to restore circulation and relieve the closure resulted in faster net gain. Frequent reliefs of vacuum for short intervals are the most effective overall. The indication is that a sort of pulse-pumping with intervals is far more effective than constant pressure. It's also logical to conclude that if the test had run for a two-hour period, the second hour score increases would have been greater than the first, because the loss of effectiveness in the control subject would be somewhat accumulative or progressive.

    One other note- the subjects were sitting and not active during the tests. Activity would help relieve some of the restriction problems. It's commonly recognized that being erect while in cylinder is more effective than a sitting position. This is due to the weight of the cylinder pulling downward, helping to reduce the pressure the vacuum can exert against the body in the seal area, thereby creating less restriction to fluid flow. If you feel you have reached your "plateau", try the take-a-break system; get your fluid passages open again, and- pump on!

  2. #2
    rain Guest

    good info

    Supra,

    Your advice on pumping is right on the mark...

    Regular breaks are best... Keep the pressure at safe levels...

    Rain...

  3. #3
    Join Date
    Dec 2003
    Posts
    8,655
    Post Thanks / Like
    Blog Entries
    2
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Rep Power
    24

  4. #4
    Join Date
    Jun 2003
    Posts
    638
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Rep Power
    15
    I do periodically, usually when I do it is in three sessions lasting 8 to ten minutes each. I will try 5 minute sessions 5 minute break and do this for one hour and see if the end outcome of pumping is different.
    Beginning Stats: 01-01-2003
    BPEL 5-1/2
    EG 4-3/8

    Current Stats: 10-09-2007
    BPEL 8-1/4
    EG 5-3/8
    Can't wait till I reach 9
    Onward and forward to bigger and better things!!!!

  5. #5
    Join Date
    Sep 2007
    Posts
    252
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Rep Power
    11

    Re: Advanced Pumping Techniques: Effective Time

    When i first began pumping this schedule you speak of is almost identical to the one i used.pumping works,like bodybuilding,you start slow and work your way up.you dont go in the gym and lift everyweight the first day,and you surely dont pump your unadapted cock for 90minutes.easy does it guys.

  6. #6
    Join Date
    Aug 2004
    Posts
    11
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Rep Power
    0

    Re: Advanced Pumping Techniques: Effective Time

    So have you guys actually seen gains from pumping?

  7. #7
    Join Date
    Jan 2008
    Location
    NJ
    Age
    47
    Posts
    18
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Rep Power
    0

    Re: Advanced Pumping Techniques: Effective Time

    about a half inch in girth and about a quarter in length...its really just for girth i think....i have had a pump for years and have used it on and off...if i use it 2-3 times a week, i get some decent size.....but i think its only good for girth

  8. #8
    Join Date
    Dec 2007
    Posts
    122
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Rep Power
    11

    Re: Advanced Pumping Techniques: Effective Time

    I tried the fourth test schedule which is supposed to be the most effective, and I didn't notice any difference from my regular routine, other than increased discomfort caused by the tube pressing on my pubic bone for an hour.

    ~Demolition Man

  9. #9
    Join Date
    Jun 2007
    Posts
    8
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Rep Power
    0

    Re: Advanced Pumping Techniques: Effective Time

    Anyone get any length results from pumping? I know its mainly girth but I was wondering if I could get any length out of it....I was told to get the flared cylinder in my size.... should I go straight to this or the other vacutech length cylinder... Just wanted some of your input cause you guys know whats up in the Penis Enlarging world

Similar Threads

  1. longer pump or 2 times a day for shorter period of time?
    By fredjones in forum Penomet Official Penis Pump Forum
    Replies: 4
    Last Post: 09-15-13, 06:30 PM
  2. Advanced Cunnilingus Techniques
    By ItsElectric in forum Sexuality
    Replies: 7
    Last Post: 08-25-13, 08:40 AM
  3. Advanced Pumping Techniques: Effective Time
    By Super in forum Alternative & Experimental Penis Enlargement
    Replies: 5
    Last Post: 01-17-08, 05:29 PM
  4. New Advanced PE Techniques by Troy Carter?
    By Lee Beast in forum Penis Enlargement Forum
    Replies: 9
    Last Post: 01-13-06, 05:42 PM
  5. How many times a week should I pump for foreskin restoration?
    By Jason1 in forum Foreskin Restoration & Foreskin Problems
    Replies: 8
    Last Post: 02-12-05, 07:11 AM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •